|
[Sponsors] |
January 6, 2013, 05:02 |
Ansys + Fluent 2-way FSI coupling
|
#1 |
New Member
Join Date: Oct 2012
Posts: 9
Rep Power: 13 |
Dear All
I am currently carrying out 2-way FSI coupling using ANSYS(14.5)+Fluent. My test problem is a thin solid membrane located between 2 fluids. I am stuck at the setup of the problem where I have to input the appropriate Dynamic Mesh settings with respect to smoothing and remeshing. The outputs are one of the following 1)Check Mesh 2)Analysis settings are not valid 3)Not all participants and system coupling system have same analysis type. I think the problem is either with the analysis settings with respect to time stepping or Dynamic Mesh Parameters or the Solver. Any inputs and queries are welcome. |
|
Tags |
ansys 14 apdl |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
drag coefficient in ansys fluent 12.0 | krishna | FLUENT | 19 | April 12, 2018 00:49 |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
2way FSI Fluent Mechanical SETUP Problems | MainzerKaiser | ANSYS | 7 | May 20, 2016 11:22 |
[GAMBIT] 3.5 years overtake by Ansys: Where are the enhancements in grid generation | Volker P. | ANSYS Meshing & Geometry | 22 | January 17, 2012 17:27 |
error in two way fsi | kmgraju | CFX | 1 | May 2, 2011 02:32 |