[EmiS]

Hello,

could you please help me figure out how to correctly set parameters for creating a plane surface using the TUI

I have the following line in my journal file (created with TUI):
/surface/plane-point-n-normal x=112mm 112. 0. 0. 1. 0. 0.

When I run the journal with:
fluent -g 3ddp -i Test.jou,
I get this warning:
" Warning : surface creation failed "

I did test the creation of the plane (with the same parameters) from the GUI and it worked all fine.

Do you know how to resolve this error? Any help is appreciated. Thank you.

EmiS

PS: I'm using ANSYS 17.0