|January 15, 2002, 04:05||
When meshing with the Coopet tool, the Gambit online manual have an example on how to mesh a combination of a cylinder, a box and a "corner". The operation is divided in 4 steps. Step no.2 is an imprint of the source faces onto each other.
My question is how this imprint is done. Is it done just by selecting the source faces or is there a special command that should be used (if yes: there is this command; I cannot find it).
|Thread||Thread Starter||Forum||Replies||Last Post|
|Gambit help: Cube inside cube||Jack Martinez||FLUENT||13||August 11, 2010 06:29|
|Gambit 2.3.16, Xming or Exceed...HELP!||bambam3417||FLUENT||10||May 7, 2010 12:39|
|Does Gambit has a maximum allowable grid number?||spartan1516||ANSYS Meshing & Geometry||7||March 25, 2010 10:08|
|Gambit -dev X11 doesn't work||Ervin Amet||FLUENT||0||October 28, 2007 09:33|
|Problem starting Gambit||ViHAR MALViYA||FLUENT||0||November 10, 2006 11:26|