|
[Sponsors] |
November 18, 2002, 12:30 |
temperature profile on boundary
|
#1 |
Guest
Posts: n/a
|
Hi all, I am having a problem with imposing a varying temperature profile on wall(2d pipe flow).The profile is wall is 153 cm long with temperature going from 900 - 1400k in 0 - 18 cm(linearly) constant at 1400k in 18 - 44cm 1400 - 700k in 44 - 60 cm(linearly) constant at 700k in 60 - 153cm I try to put this by splitting the wall into 4 different zones. The resulting temperature profile in the reactor matches the wall profile except for the first zone, where the temperature is limited to 1 k by fluent. Can anybody give me some ideas to overcome this. I would really apprecate the help. thanks in advance, sivakumar
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Boundary layer profile at inlet for cavity study in fluent | uea | Main CFD Forum | 0 | May 14, 2011 13:01 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |