|
[Sponsors] |
March 4, 2003, 22:27 |
mass imbalance(urgent)
|
#1 |
Guest
Posts: n/a
|
Hi, My system is 2D axisymmetric geometries,density is constant.In the outlet,I want to check whether mass balance, the following is some report from Fluent:
x-coordinate: 1.77E-20 y-coordinate: 2.90E-04 axial-velocity: -7.29E-03 radial-velocity: -1.23E-03 mass-imbalance: -2.23E-16 daxial-velocity-dx :5.06E+01 dradial-velocity-dx:9.88E+00 daxial-velocity-dy :-6.96E+01 dradial-velocity-dy:-3.24E+01 Anyon can tell me how to calcalate the mass balanceof this point? |
|
March 5, 2003, 05:13 |
Re: mass imbalance(urgent)
|
#2 |
Guest
Posts: n/a
|
To check mass balance, you can go to REPORT, then FLUX and then select mass balance...Choose the surfaces to compare and then click on COMPUTE. You should get the mass balance between both surfaces.
(sorry if that's what you've already done...I don't have access to FLUENT at the moment, and I cannot remember where you get these co-ordinates and velocities) Hope that helps |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass fraction of species | Lilly | FLUENT | 5 | March 13, 2022 17:52 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Running dieselFoam error | adorean | OpenFOAM Running, Solving & CFD | 119 | February 1, 2016 14:41 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Problem setting with chtmultiregionFoam | Antonin | OpenFOAM | 10 | April 24, 2012 09:50 |