CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

volume meshing

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   July 2, 2003, 22:55
Default volume meshing
  #1
nikita
Guest
 
Posts: n/a
hello friends..i still have a problem on volume meshing.i draw a small aircraft model and the model will put in the wind tunnel.so i draw the half model of the aircraft, and then create a brick which will be assume as a wind tunnel.the dimension of wind tunnle is (1*1*2.5)M.after creating this two volume, i subtract it in to 1 volume.the problem appeared when i mesh the volume,it said that check the skewness and maybe the face mesh is too big for a small gap..then i shift the position on one part of the aircraft, then, the volume mesh is success..the problem comes again when i try to export to fluent.the error is sound like this: A DEFAULT (UNSPECIFIED) BOUNDARY WAS CREATED ERROR:AN INCORRECT MESH HAS BEEN STORED.CHECK MESH QUALITY BEFORE EXPORT. VOLUME 3 HAS INCORRECT MESH AT FACE FACE63... pls advise
  Reply With Quote

Old   July 3, 2003, 02:25
Default Re: volume meshing
  #2
mateus
Guest
 
Posts: n/a
Hi!

It may be helpful if you would split your domain into more than one volume. Instead of substracting the volumes make more smaller volumes with create edge - form face - form volume...

Good luck

Mateus
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
'Tetrahedral meshing has failed for volume...' Murat FLUENT 5 February 19, 2011 05:22
On the damBreak4phaseFine cases paean OpenFOAM Running, Solving & CFD 0 November 14, 2008 22:14
Meshing volume F.A. FLUENT 3 December 12, 2005 02:31
Volume Meshing & Face Meshing? singularity of grid ken FLUENT 0 September 4, 2003 12:08
Patran Volume Meshing Deb CFX 19 April 17, 2003 11:56


All times are GMT -4. The time now is 04:37.