|
[Sponsors] |
October 14, 2008, 02:28 |
Meshing Problem
|
#1 |
Guest
Posts: n/a
|
Hi Dudes,
I have an 2d rectangular model, in which i have splitted it into 3 regions, I have to mesh the three regions separately with different mesh size. So whether i have to use interface in between these regions. Pls give me ur suggestions. With regards. Abi |
|
October 14, 2008, 05:31 |
Re: Meshing Problem
|
#2 |
Guest
Posts: n/a
|
yeah u hv to use interface.coz the common edge in the 3 regions will hv the same interval size which will prevent u from using different interval sizes.
|
|
October 14, 2008, 06:02 |
Re: Meshing Problem
|
#3 |
Guest
Posts: n/a
|
Hi rishikesh,
Pls can u explain me in detail, because i am not getting ur answer. Thanks for ur reply. With regards, Abi |
|
October 14, 2008, 06:06 |
Re: Meshing Problem
|
#4 |
Guest
Posts: n/a
|
abi jus try meshing ur geometry without using interfaces.
u will understand what i told u. Rishikesh |
|
October 14, 2008, 06:22 |
Re: Meshing Problem
|
#5 |
Guest
Posts: n/a
|
Thanks again rishikesh, then in what case we have to use interface can u tell me pls......
Regards, abi. |
|
October 14, 2008, 06:27 |
Re: Meshing Problem
|
#6 |
Guest
Posts: n/a
|
interface is used when u want different interval sizes in the same geometry and an edge or face is common to 1 or more parts that u r meshing.
if u hv any further doubt,feel free to contact me. Rishikesh |
|
October 14, 2008, 06:40 |
Re: Meshing Problem
|
#7 |
Guest
Posts: n/a
|
Hey rishikesh thanks a lot for ur quick reply, co operation and co ordination. Since I am using different mesh size in that three regions, so why can't I use that.
With regards, Abi |
|
October 14, 2008, 06:59 |
Re: Meshing Problem
|
#8 |
Guest
Posts: n/a
|
u cannot give different interval sizes to the same face/edge.
at least my experience tells me this. i am also not vastly experienced in cfd,but whatever of gambit i hv used i think this is the case. rishikesh |
|
October 14, 2008, 07:04 |
Re: Meshing Problem
|
#9 |
Guest
Posts: n/a
|
Ok thanks for spending some time for me, let me know if i have some problem.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing problem | Tomas | FLUENT | 0 | July 1, 2008 09:31 |
Meshing problem | Sanjay Jain | FLUENT | 2 | April 7, 2008 10:37 |
Meshing problem | Sanjay Jain | FLUENT | 6 | April 5, 2008 09:51 |
meshing problem | danard | CFX | 3 | March 2, 2003 19:17 |
Meshing problem | John | FLUENT | 2 | January 31, 2003 12:08 |