|
[Sponsors] |
February 13, 2012, 07:29 |
Gravity consideration in Fluent
|
#1 |
Senior Member
mohamed khedr emam
Join Date: Oct 2011
Location: Egypt
Posts: 121
Rep Power: 14 |
At the General box (beginning of fluent setup) ,the choice of using Gravity acceleration by check it and set the gravity acceleration (in x,y,z)
My question is: What the basis of choosing Gravity in calculation? Is Gravity choices depend on problem type (turbo M/c or Heat transfer , etc) Note: My study about Wind Turbine simulation (no Heat Transfer) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in reading Fluent 13 case file in fluent 12 | apurv | FLUENT | 2 | July 12, 2013 07:46 |
[ICEM] domain interface in ICEM for fluent | hsn | ANSYS Meshing & Geometry | 24 | November 27, 2012 16:43 |
fluent parallel problem in win7 x64 system | dunga82 | FLUENT | 8 | April 19, 2012 20:23 |
What the differences flow equation of Fluent 6.3 and Fluent 12.1 | opehterinar81 | FLUENT | 0 | August 19, 2011 11:55 |
Master node in parallel computing only distirubtion | syadgar | FLUENT | 1 | September 8, 2009 16:41 |