|March 22, 2012, 06:17||
Can I use a volume sink instead of a pressure outlet?
Join Date: Jul 2009
Posts: 245Rep Power: 10
I don't want to put a physical face on my domain boundary for meshing problems. Can I cut a zone out of my interior volume and make it a sink instead? A source volume (for energy, scalar etc) is easy but what about a sink that would remove mass of air and species/scalar?
Don't hesitate to ask for clarification,
Help is very much appreciated,
|Thread||Thread Starter||Forum||Replies||Last Post|
|simple model, difficult outlet||Eric||CFX||7||May 23, 2014 08:13|
|mesh airfoil NACA0012||anand_30||OpenFOAM Meshing & Mesh Conversion||12||December 12, 2011 05:16|
|Pressure outlet boundary condition||fluent_newbie||FLUENT||0||December 2, 2011 00:51|
|channelFoam for a 3D pipe||AlmostSurelyRob||OpenFOAM||3||June 24, 2011 13:06|
|Using pressure outlet BC||Shreyansh||FLUENT||0||November 5, 2010 15:57|