|
[Sponsors] |
May 23, 2011, 02:47 |
P-Q Curves in CosmosFlow
|
#1 |
New Member
Larry Lin
Join Date: May 2011
Posts: 2
Rep Power: 0 |
Hi All
I am simulating a fan P-Q curves,I have built a chamber which has a fan on the inlet,an opening pressure at the outlet,a thread nozle at the middle of the chamber.After the calculation I read the pressure drop from inlet and outlet,and the volume flow rate at the inlet fan,and plot the P-Q curves. But the simulatiom P-Q curves is very diferent from the P-Q curves given by vendor.What is wrong with my setting?? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with surface creation in ICEM from multiple curves | dialolema | ANSYS Meshing & Geometry | 2 | October 27, 2014 13:14 |
[ICEM] Coarse mesh nearer to curves | jsm | ANSYS Meshing & Geometry | 8 | September 17, 2009 07:07 |
How to remove yellow curves | Prateek jain | CFX | 4 | June 11, 2007 23:09 |
color curves | Le Stanc | CFX | 0 | December 5, 2006 07:12 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |