 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2007, 00:38
|
How to remove yellow curves
|
#1 |
|
Guest
Posts: n/a
|
Hi to every one in ICEM cfd I have some yellow curves in my geometry can any one suggest me how to remove these curves?
|
|
|
||
|
June 7, 2007, 05:10
|
Re: How to remove yellow curves
|
#2 |
|
Guest
Posts: n/a
|
Add a surface. Or just ignore them as I often do.
|
|
|
|
||
|
June 11, 2007, 03:09
|
Re: How to remove yellow curves
|
#3 |
|
Guest
Posts: n/a
|
Dear Dr. Flow, sir When I ignore the yellow curve geomatry it shows hole. how can I remove this problem?
|
|
|
|
||
|
June 11, 2007, 06:53
|
Re: How to remove yellow curves
|
#4 |
|
Guest
Posts: n/a
|
Use the "remove holes" tool witin ICEM
|
|
|
|
||
|
June 12, 2007, 00:09
|
Re: How to remove yellow curves
|
#5 |
|
Guest
Posts: n/a
|
Dr.Flow Can I remove holes before meshing.Tools are there but it is not working properly,sugest me some way to deal with this problem.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.com] OpenFOAM-1.7 bugs-Try to remove it | watashiwa | OpenFOAM Installation | 9 | November 18, 2014 17:40 |
| problem with surface creation in ICEM from multiple curves | dialolema | ANSYS Meshing & Geometry | 2 | October 27, 2014 14:14 |
| P-Q Curves in CosmosFlow | linsir0825 | Main CFD Forum | 0 | May 23, 2011 03:47 |
| [ICEM] Coarse mesh nearer to curves | jsm | ANSYS Meshing & Geometry | 8 | September 17, 2009 08:07 |
| Remove one specie and visualize overall gradient | PK | FLUENT | 0 | December 6, 2006 05:29 |
Linear Mode
