|May 23, 2011, 02:47||
P-Q Curves in CosmosFlow
Join Date: May 2011
Posts: 2Rep Power: 0
I am simulating a fan P-Q curves,I have built a chamber which has a fan on the inlet,an opening pressure at the outlet,a thread nozle at the middle of the chamber.After the calculation I read the pressure drop from inlet and outlet,and the volume flow rate at the inlet fan,and plot the P-Q curves.
But the simulatiom P-Q curves is very diferent from the P-Q curves given by vendor.What is wrong with my setting??
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem with surface creation in ICEM from multiple curves||dialolema||ANSYS Meshing & Geometry||2||October 27, 2014 14:14|
|[ICEM] Coarse mesh nearer to curves||jsm||ANSYS Meshing & Geometry||8||September 17, 2009 07:07|
|How to remove yellow curves||Prateek jain||CFX||4||June 11, 2007 23:09|
|color curves||Le Stanc||CFX||0||December 5, 2006 08:12|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|