|October 22, 2013, 11:18||
error in msh file
I deal with a hard disk drive model meshing for LES.
Iím having a trouble with writing out fluent mesh(.msh) file. In the file, I found a lot of #IND characters.
I checked blockings and other parameters but cannot find good ways.Is there any solutions?
|icem, icem 3d, meshing 3d|
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4foam building problem||GGerber||OpenFOAM Installation||54||April 24, 2015 16:02|
|problem on installing swak4Foam||navid2||OpenFOAM Installation||2||May 30, 2012 04:32|
|"parabolicVelocity" in OpenFoam 2.1.0 ?||sawyer86||OpenFOAM Running, Solving & CFD||21||February 7, 2012 12:44|
|mesh airfoil NACA0012||anand_30||OpenFOAM Meshing & Mesh Conversion||12||December 12, 2011 05:16|
|DecomposePar links against liblamso0 with OpenMPI||jens_klostermann||OpenFOAM Bugs||11||June 28, 2007 17:51|