[snappyHexMesh] Creating patch after using Snappyhexmesh -- CFD Online Discussion Forums

December 16, 2014, 05:43

Creating patch after using Snappyhexmesh

dinolsky

New Member

Dion

Join Date: Dec 2014

Location: Bremen, Germany

Posts: 13

Rep Power: 11

Hello guys,

I am facing a complication in creating a patch for my problem. I am working on a pinfin heat exchanger were a plate is placed over it . I have done with my meshing. But i want to create a separate patch for my inlet and outlet. Is there any way this can be done? Can anyone plse help me... May be to give u a rough idea i hv attached a image.

with regards,
Dinesh

Attached Images

IMG_2131.jpg (23.5 KB, 30 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
steadyUniversalMRFFoam Tutorial fails in MixingPlane	HenrikJohansson	OpenFOAM Bugs	0	February 14, 2019 04:48
Creating a udf for a patch in snappyHexMesh	Afnan	OpenFOAM Programming & Development	0	June 15, 2017 03:52
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch	gschaider	OpenFOAM Installation	225	August 25, 2015 19:43
mixerVesselAMI2D's mass is not balancing	sharonyue	OpenFOAM Running, Solving & CFD	6	June 10, 2013 09:34
chtMultiRegionFoam Tutorial	m.nichols19	OpenFOAM	12	September 9, 2010 11:56

All times are GMT -4. The time now is 05:13.