|
[Sponsors] |
[Commercial meshers] Output deck from ANSA for OpenFOAM use |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 1, 2011, 13:17 |
|
#8 |
New Member
Kattie Smilovsky
Join Date: Jan 2011
Posts: 10
Rep Power: 15 |
Hello Vangelis,
Thank you very much for the detailed response. This does help greatly. I was able to get a 3D mesh out to represent a 2D simulation. But I was unsure about whether the best way to generate a surface mesh from ANSA was using the STL output. Many thanks, Kattie |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] outputTime in Swak function | immortality | OpenFOAM Community Contributions | 20 | October 6, 2022 12:08 |
writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 06:16 |
RNG diverged during the analysis the flow over a multi element airfoil, why? | s.m | OpenFOAM Running, Solving & CFD | 0 | August 5, 2013 08:39 |
mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
lift and drag on ship superstructures | vaina74 | OpenFOAM Running, Solving & CFD | 3 | June 8, 2010 12:30 |