linking wallshearstress values and faces

prjohnston · October 13, 2009, 03:19

Hi All,

I have created a simple flow model in a cylinder and calculated the wall shear stress. I can see the wall shear stress values in the file wallShearStress, but I would like to know where these points are in space. For example, do these wall shear stress values make a loop around the wall of cylinder or do they form a line running along the cylinder? Can I see these in some way using paraFoam? I thought I had this worked out, but now I'm not sure

Any insights would be much appreciated.

Thanks very much,

Peter.

svens · November 3, 2009, 13:40

Hey Peter

A way to output the the coordinates as well as the wall shear stress is to run the post-processing tool sample.

Just enter the slice or surface of interest and add to the fields the wallShearStress.

An additional folder will be created in your case in which you can find the wallShearStresses with the corresponding coordinates.

Sven

October 13, 2009, 03:19	linking wallshearstress values and faces	#1
prjohnston New Member Peter Johnston Join Date: Mar 2009 Location: Brisbane, Queensland, Australia Posts: 25 Rep Power: 17	Hi All, I have created a simple flow model in a cylinder and calculated the wall shear stress. I can see the wall shear stress values in the file wallShearStress, but I would like to know where these points are in space. For example, do these wall shear stress values make a loop around the wall of cylinder or do they form a line running along the cylinder? Can I see these in some way using paraFoam? I thought I had this worked out, but now I'm not sure Any insights would be much appreciated. Thanks very much, Peter.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Reading values of internal faces	sega	OpenFOAM Post-Processing	6	August 29, 2017 21:09
elements, nodes and faces	Andy	CFX	10	July 7, 2013 22:40
Reading field values and setting them as boundary conditions	sega	OpenFOAM Running, Solving & CFD	1	July 7, 2009 06:18
exact face values	RubenG	Main CFD Forum	0	June 22, 2009 11:09
Fluxes of scalars at wall faces	K Sanjay	Phoenics	10	August 15, 2005 10:45

November 3, 2009, 13:40		#2
svens Member Sven Schweikert Join Date: Jun 2009 Posts: 38 Rep Power: 16	Hey Peter A way to output the the coordinates as well as the wall shear stress is to run the post-processing tool sample. Just enter the slice or surface of interest and add to the fields the wallShearStress. An additional folder will be created in your case in which you can find the wallShearStresses with the corresponding coordinates. Sven