|September 27, 2012, 11:26||
how to set concentric cylinder zones by cellZone option?
Dr Sachin Borse
Join Date: Oct 2011
Location: Pune, Republic of India
Posts: 44Rep Power: 6
I wish to make different annular cell zones in cylinder domain. how to set concentric cylinder zones by cellZone option?
|September 28, 2012, 03:20||
Niels Gjoel Jacobsen
Join Date: Mar 2009
Location: Deltares, Delft, The Netherlands
Posts: 1,641Rep Power: 25
Good morning Sachin,
One option is to make an stl surface begin a cylinder of finite wall thickness.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||34||October 16, 2014 05:27|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|Simulation of a single bubble with a VOF-method||Suzzn||CFX||18||October 2, 2009 04:18|
|increasing mesh quality is leading to poor convergence||tippo||CFX||2||May 5, 2009 10:55|