|
[Sponsors] |
how to set concentric cylinder zones by cellZone option? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2012, 11:26 |
how to set concentric cylinder zones by cellZone option?
|
#1 |
Member
Dr Sachin Borse
Join Date: Oct 2011
Location: Pune, Republic of India
Posts: 52
Rep Power: 14 |
Dear All,
I wish to make different annular cell zones in cylinder domain. how to set concentric cylinder zones by cellZone option? Regards Dr Borse |
|
September 28, 2012, 03:20 |
|
#2 |
Senior Member
Niels Gjoel Jacobsen
Join Date: Mar 2009
Location: Copenhagen, Denmark
Posts: 1,900
Rep Power: 37 |
Good morning Sachin,
One option is to make an stl surface begin a cylinder of finite wall thickness. Kind regards, Niels |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 10:55 |