blockMesh and surface mesh

doubtsincfd · June 30, 2011, 04:30

I have a surface mesh, or rather grid points on a curved surface. Now I want to build a grid in blockMesh at the same exact locations I have. Is there any way to specify each and every grid point I want on a surface and tell blockMesh to construct a grid based on those points?

Its like following the bottom to top approach. I have surface mesh and I need to construct a volume mesh in blockMesh from the available surface mesh.

AlanR · July 3, 2011, 01:26

I think you need to use snappyHexMesh. Basically, you build a cube in blockMesh around your surface with the surface slicing through the cube. Then, you use snappyHexMesh to generate a mesh that conforms to the surface and meshes the volume from your surface to the top of the cube. The motorBike tutorial is a good model to follow. I don't think you can mesh an irregular surface in blockMesh, but snappy does it quite well.

Alan

June 30, 2011, 04:30	blockMesh and surface mesh	#1
doubtsincfd Senior Member Join Date: Nov 2009 Location: Michigan Posts: 135 Rep Power: 16	I have a surface mesh, or rather grid points on a curved surface. Now I want to build a grid in blockMesh at the same exact locations I have. Is there any way to specify each and every grid point I want on a surface and tell blockMesh to construct a grid based on those points? Its like following the bottom to top approach. I have surface mesh and I need to construct a volume mesh in blockMesh from the available surface mesh.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[snappyHexMesh] problemes modelling surfaces with snappyhexmesh	gija79	OpenFOAM Meshing & Mesh Conversion	5	June 30, 2010 13:50
[snappyHexMesh] Problem with snappyHex: no body	lovecraft22	OpenFOAM Meshing & Mesh Conversion	5	June 23, 2010 11:05
[mesh manipulation] TranformPoints gives skewed mesh Possible Bug	andersking	OpenFOAM Meshing & Mesh Conversion	3	March 25, 2008 21:33
[blockMesh] BlockMesh for a rectangular domain with curved bottom surface	segersson	OpenFOAM Meshing & Mesh Conversion	0	April 17, 2006 14:11

July 3, 2011, 01:26		#2
AlanR Member Alan Russell Join Date: Aug 2009 Location: Boise, Idaho USA Posts: 61 Rep Power: 16	I think you need to use snappyHexMesh. Basically, you build a cube in blockMesh around your surface with the surface slicing through the cube. Then, you use snappyHexMesh to generate a mesh that conforms to the surface and meshes the volume from your surface to the top of the cube. The motorBike tutorial is a good model to follow. I don't think you can mesh an irregular surface in blockMesh, but snappy does it quite well. Alan