[JohannJet]

Hi everyone,

I'm currently doing some simulation on an opened door with an airflow around it. Simulations are running fine, but for some reason, I do not fully understand the setup of the moment reports.

I want to determine the moment on the door around it's hinge-axis. Air is blowing into a room behind the door and acting on the slightly opened door.

I defined a new coordinate system based exactly on the door hinge and use this as a reference. So do I understand correctly, that I choose this new system as my coordinate system . The Axis origin is 0,0,0 and the axis I want to know the moment of, is the x-Axis - so as Axis I define 1,0,0.

As parts, I only select the door?!

I hope my questions are understandable - otherwise I can try to clarify.

Regards
John