 |
 |
 |
|
|
|
[Sponsors] | ||||
July 25, 2012, 05:38
|
HEXA mesh
|
#1 |
|
New Member
Rémi Issac
Join Date: Jul 2012
Posts: 6
Rep Power: 13  |
hello everyone,
I wanna figure out the hexa mesh of the geometry in attach, as you can see in the blk document, I try to dig out a little cuboid in the center. But I always meet the problem of Volume Orientation who is not able to be fixed, what I do is just delete those bad nodes. Then when I export this mesh to Fluent, it mentions Aborted due to critical error, non of the signs else. Could you please take a look at of the blk where my mistakes are, what I can do now? cause I'm quite new in using ICEM and I spent pretty much time on this Thanks a lot Last edited by freedomman; July 26, 2012 at 10:15. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [ICEM] export hexa mesh to fluent | Wieland | ANSYS Meshing & Geometry | 37 | January 23, 2013 03:27 |
| [ICEM] Hexa Mesh Smoothing | Jules | ANSYS Meshing & Geometry | 6 | December 4, 2010 18:00 |
Threaded Mode
