|
[Sponsors] |
June 12, 2012, 04:45 |
sweeping 2D Boundary Layers
|
#1 |
New Member
kkk
Join Date: Jun 2012
Posts: 7
Rep Power: 13 |
Hello,
I have difficulties meshing a volum with two of its faces having 2d BL. Indeed, i have to blocks, one should be mesehd with two times less cells than the other. For the transition, i use a BL (with 3 rows). I mesh then the face, Gambit tells me that the face is meshed with poor quality and once i sweep it to obtain the volum, then i have chaotic lines growing randomly. How can i extend the BL to the volum i want to obtain? Thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
[ICEM] Problem with boundary layers for cylinder in channel | nik | ANSYS Meshing & Geometry | 0 | October 27, 2009 06:01 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Boundary layers problem | carlos ortiz | FLUENT | 0 | September 20, 2004 20:55 |