|
[Sponsors] |
June 23, 2012, 14:41 |
U-bend Mesh in ANSYS
|
#1 |
Member
John
Join Date: Jan 2011
Posts: 69
Rep Power: 15 |
I'm trying to mesh a U-bend in ANSYS for later FLUENT simulations.
I can't think of a proper mesh to adopt in this case (180 degrees pipe). I would believe a C-grid is the most reasonable. But I lake the expertise to do such complex grid using ANSYS MESH. Anyone have good tutorial or idea of how to mesh this complex geometry, would be much appreciated? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |