|
[Sponsors] |
[ICEM] The pre-mesh quality is very good but the mesh quality is bad |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 27, 2012, 11:27 |
The pre-mesh quality is very good but the mesh quality is bad
|
#1 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
Hi everyone,
Here is my question about mesh generation by ICEM. My pre-mesh quality is very good by the button 'check pre-mesh quality' . But after I convert it to mesh, the mesh quality is very bad by the button 'display mesh quality'. Should I go back to block to redo my block to solve this problem? Or I can trust the 'pre-mesh quality' and run the case directly? Best regards and many thanks, lnk |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
erroneous temps in conjugate model? | sieginc. | STAR-CCM+ | 11 | July 14, 2012 03:41 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |