[vmlxb6]

Hello everyone,

I am trying to mesh the region of an exhaust manifold for structural as well as fluid simulation. Now I have been told that everything in the IGES model needs to be meshed. The problem is that the model consists of fluid region + the structural region with bolts and washers and spacers.
I have always used ICEM for CFD and never for structural purpose. I am not sure how I should go about doing this. Are there any tutorials available for meshing multiple components together.
I would have managed if it was just the structure or just the fluid region but now its the fluid as well as the structure with bolt and washers.

Any kind of advice would be appreciated. Thank you very much.

Regards,


vmlxb6