|
[Sponsors] |
[ANSYS Meshing] Solid to Solid Interface Issue |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 22, 2012, 16:41 |
Solid to Solid Interface Issue
|
#1 |
New Member
Chris Cvetkovski
Join Date: Oct 2012
Posts: 1
Rep Power: 0 |
Hi,
My geometry incorporates a solid portion encased in another solid portion with a fluid tube in the centre. I set up this model in the design modeler and then after meshing the structure FLUENT I only get one solid in the cell zone boundaries section (the fluid) and I get: Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface. I believe the problem lies in the meshing component. Has anyone here run into something similar or do any of you have any ideas? Thanks Chris Cvetkovski |
|
Tags |
ansys, geometry interface, interface, mesh, solid |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Grid interface issue | CaroVandame | FLUENT | 6 | May 5, 2012 14:37 |
Solid-fluid Interface question | shankara.2 | ANSYS Meshing & Geometry | 2 | September 14, 2011 12:49 |
Solid-air interface and conduction through the solid body | aggie | FLUENT | 0 | June 21, 2011 12:34 |
Solid to solid thermal interface | LaurenB | FLUENT | 0 | December 22, 2009 13:26 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |