|
[Sponsors] |
December 13, 2012, 00:38 |
Help with meshing
|
#1 |
New Member
KB
Join Date: Jan 2012
Posts: 9
Rep Power: 14 |
I will appreciate if anybody could come to my aid. I meshed this profile with surface meshing, as shown in the picture. I am not contented with the results.. However, I would have love to use the Blocking method but due to my limited knowledge. I have constraint because the top and bottom boundary is periodic so if I try to do blocking I get negative volume.I have to generate this boundary for different spacing.
Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |