|
[Sponsors] |
|
February 12, 2013, 06:25 |
Gambit help
|
#1 |
New Member
Alok Deshpande
Join Date: Oct 2010
Posts: 10
Rep Power: 15 |
Hi All,
I have a domain like below. Opposite edges have same mesh count. https://picasaweb.google.com/1162266...25166580661154 Quad/Map or Quad/Submap should mesh the face like this, (I have made it out of 5 different faces just to show you.) https://picasaweb.google.com/1162266...25169778632082 But when I mesh it as a single face, it becomes, https://picasaweb.google.com/1162266...25170248959090 Any thoughts? Thanks |
|
February 12, 2013, 08:09 |
|
#2 | |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
Quote:
With surface decomposition, you always have more control on your mesh. You just demonstrated it
__________________
In memory of my friend Hervé: CFD engineer & freerider |
||
February 12, 2013, 08:17 |
|
#3 |
New Member
Alok Deshpande
Join Date: Oct 2010
Posts: 10
Rep Power: 15 |
||
February 12, 2013, 11:24 |
|
#4 |
New Member
Alok Deshpande
Join Date: Oct 2010
Posts: 10
Rep Power: 15 |
hi mAx,
Now that I have 2 zones, what should be the boundary type for the edge that connects these two? Interface?? Thanks in advance! |
|
February 13, 2013, 05:01 |
|
#5 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
don't set anything on this edge. Thus if your split is well done, then both domains are connected, and Gambit will automatically set this edge as interior.
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
February 14, 2013, 03:15 |
|
#6 |
New Member
Alok Deshpande
Join Date: Oct 2010
Posts: 10
Rep Power: 15 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
between IDL Gambit and rhino, any help? | philip | FLUENT | 0 | June 23, 2005 12:08 |
Generating big meshes with GAMBIT on NT | Andrew Ooi | FLUENT | 12 | February 2, 2000 22:26 |