 |
 |
 |
|
|
|
[Sponsors] | ||||
June 5, 2013, 09:04
|
3d structured mesh
|
#1 |
|
Senior Member
mohsen kh
Join Date: Jan 2013
Location: Iran
Posts: 125
Rep Power: 14  |
Hi friends
I post a thread about my problem in meshing with Gambit. my model is a furnace with 72 eliptic holes around it.I want to remove some holes from the section of furnace which was shown in attached photos. I do not know how to mesh my volumes to have a structured map mesh. I used to create surface and then substract it frome the surface of volume to call them inlet in my model but some one told me to create them as volumes. I want to have a map mesh or cooper but I do not know how to create it.  please help me if it is possible for you thanks http://i41.tinypic.com/33cx8ut.png http://i41.tinypic.com/5bz2th.png http://i42.tinypic.com/autgs1.png |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| Block structured hexagonal mesh vs automated tetra mesh inside Workbench for CFD | Chander | CFX | 3 | November 27, 2011 16:24 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
1Likes
Threaded Mode
