|
[Sponsors] |
July 14, 2013, 22:49 |
unknown pre-mesh distortion
|
#1 |
New Member
Join Date: May 2013
Posts: 8
Rep Power: 13 |
Dear veteran meshers,
After long and repeated meshing work ,i got quite a frustrated results:the mesh over one side of the aircraft is mysteriously distorted ,while the opposite side is fine.The two sides are symmetrical. I did the association work for curves and faces all over again,but the results are the same.Can you help locate the problem of this issue,I really don't want to redo the blocking and splitting.... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Mesh distortion close to cylind wall-GAMBIT 2.2.30 | Mirek | FLUENT | 1 | April 15, 2006 17:22 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |