|
[Sponsors] |
August 12, 2013, 09:23 |
Dealing with detached curves
|
#1 |
Member
Matthew Rich
Join Date: Jul 2013
Posts: 33
Rep Power: 12 |
Hi all
I am having difficulty getting lines attached to surfaces. I went through and was patching up surfaces not paying attention to the curves whatsoever. My initial mesh had some holes and I was reading that was attributed to not having clean curves. So now I am going back through part by part trying to fix them up. If I use the diagnostic tool, I get the figure below. Very little red or blue and I am not sure how to fix? I tried extracting curves from surfaces but that gives me all greens and making surfaces from green lines doesn't help either. Any advice? Pulling my hair out here thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with surface creation in ICEM from multiple curves | dialolema | ANSYS Meshing & Geometry | 2 | October 27, 2014 13:14 |
[ICEM] Error 2D mesh - Separate curves seen as one when associating | bbmorales | ANSYS Meshing & Geometry | 3 | June 11, 2013 11:56 |
[DesignModeler] Create Skin from Curves by a JScript | Red | ANSYS Meshing & Geometry | 0 | February 26, 2013 11:16 |
Version 7.04 : disappearing feature curves and other woes | nomad | STAR-CCM+ | 2 | September 4, 2012 21:07 |
[ICEM] Coarse mesh nearer to curves | jsm | ANSYS Meshing & Geometry | 8 | September 17, 2009 07:07 |