|
[Sponsors] |
[ANSYS Meshing] Automatic mesh generation by batch file |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2013, 17:36 |
Automatic mesh generation by batch file
|
#1 |
New Member
Neal
Join Date: Sep 2013
Posts: 4
Rep Power: 12 |
I currently have a parameterized geometry and mesh file in work bench that I change the parameters on to run multiple cases. I would like to instead have a batch file that generates the geometry and mesh for me with named selections that can be imported by another batch file into a CFX Pre and run by command lines in a third batch file.
I have a starting point to look at the coding for the Pre and solver batch files because i can use the command line editor in Pre. I am somewhat lost as to where to find information on generating geometry and mesh from a batch command. Any suggestions where to look or directions to some appropriate guides would be appreciated. |
|
Tags |
batch, geometry preparation, mesh generation |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |