 |
 |
 |
|
|
|
[Sponsors] | ||||
May 29, 2014, 10:43
|
Meshing a Turbine Bladepassage
|
#1 |
|
Member
Daniel Frederik
Join Date: Apr 2014
Location: Switzerland
Posts: 38
Rep Power: 12  |
Hi everybody,
I'm currently simulating a radialturbine. While Meshing the TurbineBlade i noticed that TurboGrid meshes the blade not within the Geometry Zone defined by BladeGen (see Picture). The Mesh is shifted to the right. Is that normal? Thanks for the responses Daniel |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Meshing a wind turbine for wing tip vortexes | Grog106 | ANSYS Meshing & Geometry | 1 | March 29, 2012 06:07 |
| Meshing Volume in Gambit for a water turbine | Zaqie | FLUENT | 1 | July 24, 2009 01:25 |
| Marine current turbine (meshing and stimulation help needed!!) | coolyihao | FLOW-3D | 0 | March 16, 2009 11:48 |
| Q: how to do a good meshing in turbine usin gambit | oscar | FLOW-3D | 1 | March 14, 2009 23:15 |
| turbo turbine meshing with gambit | Mak | FLUENT | 3 | October 2, 2008 06:31 |
Threaded Mode
