[Henry Arrigo]

Hi all
I am going to mesh a parametric cantilever beam subjected to a fluid flow. I want to use ICEM for this purpose. Doing so, when I update the main parameters of the beam, for example the cross section length, the blocks in the ICEM module don't get updated. Here, I show what happened to blocks when I change this length from 500 (pic1) to 250 (pic2). I was expected to have an updated o-grid and split, but non of them was happened. Although I guess writing script would be the solution, I 'd rather to do this without getting involved with scripting. I do these in ANSYS Wrokbench, with a Geometry upstream cell and CFX downstream cell, so it s important for me to us the straightforward options.
Thank you.