|
[Sponsors] |
November 11, 2014, 03:51 |
Problems
|
#1 |
Senior Member
Join Date: Oct 2014
Posts: 124
Rep Power: 11 |
Hi everybody.
When I read the mesh file with Fluent two errors appear: 1) "Building... mesh auto partitioning mesh by Principal Axes Warning: Partition method "Metis" is not allowed for autopartitioning for cases with non conformal interfaces before the interfaces are defined and intersected, use "Principal Axes" instead. You may use the "Metis" partition method after the case is read in and the interfaces are intersected.," 2) Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface. Since there is the rotating domain of the water wheel I have created interfaces. Despite these errors, the model reaches convergence, but the calculated torque is wrong. Anybody can help me? The previous two errors are negligible or not? Thank you |
|
Tags |
interface, metis, rotating domain, turbine, water wheel |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[mesh manipulation] Problems with rotational cyclic boundaries | TReviol | OpenFOAM Meshing & Mesh Conversion | 8 | July 11, 2014 03:45 |
[ICEM] Flow channel meshing problems | StefanG | ANSYS Meshing & Geometry | 19 | May 15, 2012 06:44 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 05:44 |
Help required to solve Hydraulic related problems | aero | CFX | 0 | October 30, 2006 11:00 |