|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Tomas Koutnik
Join Date: Feb 2015
Location: Czech Republic
Posts: 2
Rep Power: 0 ![]() |
Hello everyone!
I was using an old TGrid 5.0.6 for 2D meshing of multielement airfoils, but the license is over now and can't be renewed (Ansys doesn't support this software anymore). I know, TGrid is now part of Fluent, but it's 3D only. I tried to do some structured meshes in Icem instead, but it costs way more time and the result is more likely to fail when I'm changing the geometry through scripts. I would be very grateful for any tips on 2D unstructured/hybrid meshers You have good experience with, which could be suitable replacement for the good old TGrid. I know there are many of them, so, which one is Your favourite? Thank You for all Your recommendations. Last edited by Tuco; April 5, 2015 at 06:30. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Cannot convert fluent or tgrid hexcore mesh | aerogt3 | OpenFOAM Meshing & Mesh Conversion | 2 | October 22, 2010 11:55 |
CFX Pre - TGrid | Vivek Vasudevan | CFX | 2 | March 20, 2007 06:31 |
TGrid: segmentation violation error | Vincent | FLUENT | 0 | February 15, 2006 10:34 |
Drawing in TGrid | Harmeet | FLUENT | 0 | September 22, 2004 03:56 |
to tgrid or not to tgrid | Nurul Murad | FLUENT | 1 | July 6, 2001 13:21 |