|
[Sponsors] |
April 27, 2015, 04:26 |
Same length curve mesh
|
#1 |
Member
Jinwhan Ryuk
Join Date: Feb 2013
Location: South Korea
Posts: 91
Rep Power: 13 |
Does anyone know how to find same lengh curve and divide them by n numbered mesh?
I think there will be such a macro or icon to find same length curve in ICEM CFD but I can't find it. There are many same small lengh curve and I have to divide them to make fine mesh. It is quite difficult job to pick every small length of curves and divide them by using curve mesh setup icon. |
|
April 27, 2015, 20:40 |
|
#2 |
Member
Jinwhan Ryuk
Join Date: Feb 2013
Location: South Korea
Posts: 91
Rep Power: 13 |
How can I delete this post?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[snappyHexMesh] problems generating clean mesh | Christian_tt | OpenFOAM Meshing & Mesh Conversion | 2 | June 20, 2019 05:39 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |