|
[Sponsors] |
[ICEM] using ogrid for meshing a volute not successful |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 14, 2014, 04:02 |
using ogrid for meshing a volute not successful
|
#1 |
Senior Member
tmeysam92
Join Date: Jun 2011
Posts: 135
Rep Power: 14 |
Hi all,
i meshed a volute. i checked the quality of the mesh. it is not good. i have to use ogrid. but when i am using the ogrid tool, it gives me error. "ogrid not successful" how can i solve this problem. Thanks in advance. |
|
June 25, 2015, 14:59 |
|
#2 |
New Member
Join Date: Apr 2015
Posts: 8
Rep Power: 11 |
Hi,
Did you figure this out? I am having the same problem as you. Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problem: Ogrid outside the block | Fred_Erik | ANSYS Meshing & Geometry | 3 | August 7, 2017 03:39 |
[ICEM] Ogrid not successful | clocter | ANSYS Meshing & Geometry | 3 | November 10, 2013 05:40 |
[ICEM] unwanted pre-mesh inflation around Ogrid | macfly | ANSYS Meshing & Geometry | 7 | September 25, 2012 09:41 |
ogrid in ogrid | susan | CFX | 4 | December 20, 2007 05:58 |
volute geometry definition | Derrik Mazzer | CFX | 2 | May 15, 2001 08:20 |