|
[Sponsors] |
[ANSYS Meshing] Model Information is incompatible with incoming mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 11, 2015, 09:09 |
Model Information is incompatible with incoming mesh
|
#1 |
New Member
abtin hesami
Join Date: Oct 2015
Posts: 4
Rep Power: 10 |
Dear all,
I faced to this msg in setup, but i can not find the following steps, which described below. ( ansys 16), can any one help me. Found some missing and new zones in the mesh. To make mesh compatible with settings, please visit "Match Zone Names" panel (Mesh->Recorded Mesh Operations->Edit Incoming Zones... -> Match Zone Names...). Thank you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 14:32 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Ansys workbench GDO model information is incompatible with incoming mesh | shuweixin | ANSYS | 0 | August 9, 2013 19:05 |
k-e model and mesh sensitivity | raj calay | Main CFD Forum | 13 | July 28, 1999 15:48 |