|
[Sponsors] |
[ANSYS Meshing] How to avoid Failed Meshing in condition of small interspace between Models? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 26, 2016, 11:58 |
How to avoid Failed Meshing in condition of small interspace between Models?
|
#1 |
New Member
D_K
Join Date: Jan 2016
Posts: 5
Rep Power: 10 |
Hi everybody, I am currently doing a cfx simulation about aerodynamic parts of racing car.
In my model there is a small interspace between main body shell and end plate of front wings, which I think is the reason why failed meshing happens. I have tried different settings of mesh(sizing,inflation). all failed. I have done all simulations of every single part(main body, front wings,rear wings etc), the meshing are perfect, no such problem. It seems this problem only happens in the case with assembly parts. Do you guys know how to avoid this mesh problem if i keep the model like this? Or do you guys have ever similar experience? |
|
Tags |
aerodynamic, interspace |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'Tetrahedral meshing has failed for volume...' | Murat | FLUENT | 5 | February 19, 2011 04:22 |
Meshing a small section in GAMBIT | Anne | FLUENT | 4 | May 12, 2008 12:04 |
Avoid small surface areas | UncleToby | Main CFD Forum | 0 | January 3, 2008 08:04 |
meshing very small tubes | Wooster | CFX | 6 | July 23, 2007 10:41 |
CFX 5.5 | Roued | CFX | 1 | October 2, 2001 16:49 |