|
[Sponsors] |
[ANSYS Meshing] total height of prism layers, determination of a desired y+ value |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 2, 2016, 18:07 |
total height of prism layers, determination of a desired y+ value
|
#1 |
Senior Member
cyln
Join Date: Jul 2016
Posts: 102
Rep Power: 9 |
Hello,
I have been working on ICEM to generate a mesh for an engine exhaust mixer and I am very close to finishing the mesh. However, I have a few questions to ask. 1. how can I determine the total height of the prism layers? you can see what my geometry is like below. The mixer is surrounded by tetra mesh; however, there are prism layers near the walls in order to resolve the boundary layer. 2. How can I determine a desired y+ value? Then I will calculate the first cell height. I know that y+ value has different ranges for different turbulence models. I will be using SST turbulence model. 3. In some of the papers (with similar geometries), in order to define the spatial resolution around the walls of the mixer, there are some Deltax+ ,rDeltaTheta+ values and r+ value for the first node above the wall. But I couldnt find these on any book. I guess they are related to y+ value. What are these values? Thanks a lot in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] How to improve bad quality elements that are obtained after creating prism layers? | Rohith Giridhar | ANSYS Meshing & Geometry | 2 | July 11, 2015 18:04 |
[ICEM] Element sizing question | siw | ANSYS Meshing & Geometry | 4 | January 22, 2015 09:11 |
Error in run Batch file | saba1366 | CFX | 4 | February 10, 2013 01:15 |
Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
[ICEM] Error in Prism Ratio Computed | singer1812 | ANSYS Meshing & Geometry | 0 | September 22, 2011 16:29 |