|
[Sponsors] |
[TGrid] compresor cavities modeling using TurboGrid |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 16, 2016, 02:51 |
compresor cavities modeling using TurboGrid
|
#1 |
Member
Alex
Join Date: Feb 2016
Posts: 81
Rep Power: 10 |
Hi to all
How can I simulate compressor bleeding and cavities using TurboGrid only? Is it possible just to add cavern to shroud/hub curve? Whether it is necessery to combine TurboGrid and ANSYS Meshing or not? Thanks in advance |
|
November 14, 2016, 01:37 |
|
#2 |
Member
Alex
Join Date: Feb 2016
Posts: 81
Rep Power: 10 |
Still no ideas?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] TurboGrid - problem with trailing edges ending with hub/shroud curve | TTM | ANSYS Meshing & Geometry | 8 | February 16, 2020 07:11 |
Files input for Turbogrid | Jun_Milan | CFX | 0 | July 10, 2014 23:34 |
May Focus Area: Turbulence Modeling | Jonas Larsson | CFD-Wiki | 0 | May 2, 2006 11:48 |
Modeling Flow/Saturation/Absorption in Fibers | Gene Dougherty | Main CFD Forum | 0 | June 6, 2003 14:49 |
CFD Modeling of Two-phase Flow in Small Dia.Tubes | Eric Poindexter | Main CFD Forum | 2 | September 22, 2000 09:21 |