|
[Sponsors] |
[ANSYS Meshing] Two bodies, same settings, wrong result. Please help us |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 6, 2017, 09:12 |
Two bodies, same settings, wrong result. Please help us
|
#1 |
New Member
Jakob Lindqvist
Join Date: Dec 2016
Posts: 9
Rep Power: 9 |
Hello!
Starting with two pictures in this link: http://imgur.com/a/TJnV9 The geometry is divided by two parts named as one part in DM. The geometry is representing a pipe with a contraction halfway into a smaller pipe. The geometry is a revolve of 10°, the bigger pipe diameter is 19,1 mm and the smaller pipe diameter is 10,2 mm. Length of each pipe is 0,3 m. I need these two bodies to make the same pattern showed in the second picture (upper part). When only meshing part 1, the bigger geometry of the pipe, I get the same pattern all the way with no irregularities. But when adding the smaller pipe with the same settings, I get the result showed in the pictures. How do I force them to mesh with the same grid? They are already dependent on the same sizing and methods so It's really confusing to us /Jakob |
|
Tags |
meshing cylinder |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh matches wrong cells to CellZone | Siegunn | OpenFOAM Meshing & Mesh Conversion | 4 | July 31, 2015 05:10 |
Wrong Result from Simulation...using Autodesk Project Falcon.. | addy01 | Main CFD Forum | 3 | March 4, 2013 05:41 |
Multiphase modelling using Fluent VOF: Solver settings | akash | FLUENT | 0 | February 22, 2013 06:29 |
Wrong result with bilinear interpolation | zonexo | Main CFD Forum | 1 | June 12, 2007 15:55 |
3 bodies in 1 part | Atit | CFX | 7 | October 22, 2004 14:41 |