|
[Sponsors] |
[ANSYS Meshing] Multizone with an inflation layer for CFX |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 21, 2017, 17:01 |
Multizone with an inflation layer for CFX
|
#1 |
Senior Member
Join Date: Mar 2013
Location: Germany
Posts: 357
Rep Power: 14 |
Hi All
I have a problem with this Hexa mesh to be specific I am trying Multizone mesh with some inflation layer for CFX in Ansys mesh, but unfortunately its not working or it says the meshing is not successful and stops with some error message. I read somewhere that Hexamesh/Multizone doesnt work with CFX and it only works for fluent. Is it true ? For me if I just give the Multizone and do a mesh it works but when I give sizing or inflation or sphere of influence ( to mesh more fine at a particular region) it ends with error message and also takes lot of time on my desktop. Can some one help me with this issue. I want to do LES simulation hence trying to make a decent mesh with very fine scales. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] 2D inflation layer contains triangles | jones007 | ANSYS Meshing & Geometry | 8 | May 4, 2020 08:42 |
[ANSYS Meshing] Problems with creating a hex-uniform MultiZone Mash with Inflation | AnnaF | ANSYS Meshing & Geometry | 4 | April 19, 2019 06:24 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
[ANSYS Meshing] Inflation layer near gap with multizone mesh | matmax-168 | ANSYS Meshing & Geometry | 0 | April 24, 2015 09:32 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |