|
[Sponsors] |
[ANSYS Meshing] structured mesh for geometry with pyramid |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 23, 2017, 10:17 |
structured mesh for geometry with pyramid
|
#1 |
New Member
Asal
Join Date: Jan 2016
Location: Belgium
Posts: 5
Rep Power: 10 |
Dear all,
I have this geometry which composes of some pyramid bodies and some bodies which are sweep able. However when I use the multi zone method and select all the bodies, it produces a large amount of cell (11M) and also in some area the minimum orthogonal quality is very low (0.08). Any idea on how to mesh it to have a good quality mesh. Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Volume mesh for Cyclone separator | Rajan | Pointwise & Gridgen | 17 | May 4, 2014 05:38 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |