|
[Sponsors] |
March 15, 2012, 10:10 |
Cylinder Meshing
|
#1 |
New Member
Join Date: Mar 2012
Posts: 4
Rep Power: 14 |
I was wondering what the best process for using ICEM would be to mesh a cylinder. I wanted the circular surface to have a mesh that radially grows from the center. I have tried using ANSYS meshing but I could not get the circular surface to complete the radially mesh. I had gotten around this by using a small square in the middle of this surface and divided the rest of the surface into four pieces. I am now trying to find a way to get a purely radially mesh. I am new to ICEM and was just wondering what the process would be to complete this mesh, if possible, in ICEM.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
meshing on cylinder fails ICEM | potac | ANSYS Meshing & Geometry | 0 | October 25, 2011 05:21 |
2D planar cylinder meshing problem | saisanthoshm88 | ANSYS Meshing & Geometry | 15 | December 27, 2010 11:14 |
[ICEM] (ICEM CFD) meshing over a cylinder | vmlxb6 | ANSYS Meshing & Geometry | 6 | August 11, 2010 14:37 |
[blockMesh] Meshing inside a cylinder so that the edges contain more cells than the center | Bertrand | OpenFOAM Meshing & Mesh Conversion | 1 | April 13, 2010 04:46 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |