 |
 |
 |
|
|
|
[Sponsors] | ||||
May 18, 2017, 11:22
|
Ignoring Overlapped Surface
|
#1 |
|
New Member
Join Date: Jul 2015
Posts: 14
Rep Power: 10  |
Hi everyone!!
In the picture attached you can see the forward facing step I'm studying using an structured mesh. The problem is that I would also want to include a model of the circular balance used in the wind tunnel to measure the forces. (see image) How can I keep the structure mesh all the way until the step and then afterwards calculate the forces only over the balance?? I've tried to merge the faces in design modeller and use name selection but I can't get the balance to be isolated from the mesh |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| Patran Volume Meshing | Deb | CFX | 19 | April 17, 2003 10:56 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
Linear Mode
