|
[Sponsors] |
July 16, 2017, 07:40 |
problem with Meshing method
|
#1 |
Senior Member
yaseen
Join Date: Oct 2015
Location: Hawler
Posts: 174
Rep Power: 10 |
I want to simulate flow over the weir, but I have a problem in meshing, although the geometry is simple but the mething method such as multizone, sweep does not progress, it shows an error message said (The MultiZone meshing has completed, but no volume elements were created. This may be caused by unsupported circular sweeps), only for hexa core there is no problem but, as I understood this method does not convenient for CFD.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM CFD] Problem meshing two indipendent but contacting bodies | Faggio11 | Main CFD Forum | 0 | December 12, 2016 09:31 |
Problem with 'Mapped Face Meshing' | RobertW | FLUENT | 0 | November 19, 2016 15:39 |
[ANSYS Meshing] Problem with sweep Method | MrNavierStokes | ANSYS Meshing & Geometry | 4 | November 7, 2016 14:08 |
[ICEM] Problem with meshing half NACA0009 in 3D | Eizo | ANSYS Meshing & Geometry | 30 | February 17, 2013 02:40 |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |