 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Inflation along contact region |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 28, 2018, 15:12
|
Inflation along contact region
|
#1 |
|
New Member
Join Date: Feb 2018
Posts: 1
Rep Power: 0  |
Hi,
I'm trying to mesh a half cylinder with two parts (see attached picture). When I try to add inflation to the curved surface, I got a narrow inflation region in the bottom part. I don't get this behavior if the geometry is one part/body but I need to use two different mesh sizing in these two parts. Any solution to have a uniform inflation along all the curved surface? I'm using ANSYS meshing software and I'm a beginner. Thanks. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 14:26 |
| conjugate heat transfer in OpenFOAM | skuznet | OpenFOAM Running, Solving & CFD | 99 | March 16, 2017 05:07 |
| HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
| Taking too much for run | Grimoli | OpenFOAM Running, Solving & CFD | 5 | November 26, 2013 20:07 |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
Linear Mode
