[alvinthum]

Hello all,
Below there are two pictures are the mesh from the paper, another is my meshing. At first, i thought i doing good in meshing because is similar to the paper but got people said my meshing is terrible.

mesh from alvin.jpg

mesh from thesis.png

half pipe mesh from thesis.png

From the paper i refer, it stated that the inlet, outlet and symmetrical region are appropriately defined and subjected to sweep mesh by inflating the boundaries. Also, the inlet and outlet are subjected to extruded mesh. This is further followed by surface mesh and volume mesh.

So i wanna know how to do the sweep mesh by inflating the boundaries. This is because when i choose method as sweep mesh, i will not able to do inflation from the boundaries. So at the end, i try to change the SRC/TRG
from automatic to manual souce. Then i was able to create the mesh but not sure correct or not. Below some of the picture is the step i do the mesh with sweep method and inflation, i dont know is correct or not.
sweep method.jpg
inflation.jpg

Hope someone can help me about this. Thanks you very much.

May you all be well and happy, alvin